Turbosmart BOOST CONTROLLERS – ELECTRONIC - e-Boost2 (2005-cu Manual de usuario Pagina 5

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 38
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 4
www.TURBOSMARTONLINE.com
5
Wiring
- The e-Boost2 must be connected to a typical automotive12 volt negative earth electrical system.
- Soldering or Crimp on electrical connectors must be used on all electrical connections
- Unused wires must be insulated with electrical tape so that they do not touch other wires or the chassis
- Refer to the following table and diagram for detail on wiring the e-Boost2.
Wire Connect to
RED + 12 Volts switched through ignition – connect via 5 Amp fuse supplied
BLACK Chassis, earth or ground
GREY Solenoid wire 1 – connect using wire supplied – polarity not important
BROWN Solenoid wire 2 - connect using wire supplied – polarity not important
YELLOW RPM signal from ECU or negative terminal of an ignition coil OPTIONAL
WHITE Auxiliary output – switched to ground – see diagram below OPTIONAL
GREEN External set point switching OPTIONAL
ORANGE External set point switching OPTIONAL
Vista de pagina 4
1 2 3 4 5 6 7 8 9 10 ... 37 38

Comentarios a estos manuales

Sin comentarios